Action: PrDinSLc/PrDinSSup

PrDinSLc/PrDinSSup Calculates a principal tensile stresses according DIN standard for serviceability state for certain envelope or load case.

Setting

Description

Action will be skipped (Option)

The action will be skipped in the calculation process if the option is selected.

Command

This is automatically assigned from the previous selection - it can not be edited in this pad.

Load case/Superposition file

Name of the envelope (superposition file), or load case name, for which the check will be done

RMSET

Name of RMSET, where certain additional information have to be defined

RMSET has to use certain keywords:

Key	PRDIN
Inp1	Material name(without group) - f.ex. B_35
Inp2	SERVICE (Limits for service state) REIN (Limits for dimensioning)
Inp3	SIG1..... Limits for main tensile stress SIG2..... Limits for main pressure stress then ....Q.....Limit for main stress, caused by shear ....T.....Limit for main stress, caused by torsion ....QT....Limit for main stress, caused by shear+torsion ......FL..Limit for web (plates) Following combinations are possible: SIG1Q, SIG1T, SIG1QT, SIG1QFL, SIG1TFL, SIG1QTFL SIG2Q, SIG2T, SIG2QT, SIG2QFL, SIG2TFL, SIG2QTFL
Inp4	Stress limit - f.ex. 2200

Example:

"PRDIN"    "B_35"    "SERVICE"    "SIG1Q"    "2200"

List File

Name of list file, where the principal tensile stresses will be stored.

-If the default '*' is accepted, the name of the list file is set automatically prds0001.lst if the load case name is 1, prdsnormal.lst, if the superposition file is normal.sup.
-If there is no input, no list file will be created!

Delta-T

Duration of the Action (not applicable for this action)

Description

Descriptive text for the selected Action (max. 80 characters)